...
 

OmniRig

This software uses OmniRig from http://www.dxatlas.com/omnirig/ for radio control. OmniRig must be installed before using the external radio display, see below for more information.

To configure Omni-Rig you must open the external radio options, to do this press the ? button in the external radio window.

  • Use the Serial Ports page to find the ports on your computer.
  • In OmniRig set the Poll Int. ms (polling interval in milliseconds) to 100 (or lower if supported). If you do not set a low polling interval the response will be sluggish.
  • Check the baud rate selected in OmniRig and the baud rate on your radio are the same. A higher baud rate will give a better response but can return erratic values if set too high.
  • Check the OmniRig website and support groups for your radio to ensure you have the latest OmniRig support files (.ini).

April 23rd, 2016: the file to download and install is on http://www.dxatlas.com/Download.asp the file is OmniRig http://www.dxatlas.com/OmniRig/Files/OmniRig.zip , this contains radio definition (.ini) files. The very latest .ini files are in http://www.dxatlas.com/OmniRig/Files/RigIni.zip .

Diagnostics

In the Logfile pane you can enable [X] Verbose logging and the [X] Debug option when helping diagnose problems. When debug is selected all entries written to the logfile are also sent to the current debugger, for example DebugView which is downloaded for free from https://technet.microsoft.com/en-us/sysinternals/debugview .


TS-2000

Added one line to bottom of file for TRANSMIT

Last section should be: 

[STATUS6]
Command=(TX;)
ReplyEnd=(;)
Validate=(TX.;)
Flag1=(..0.)|pmRX
Flag2=(..1.)|pmTX
Flag3=(..2.)|pmTX 

This allows SDR Rx mute using SDR Console V3 when rig transmits.

Thanks,

Don Rasmussen Wb8yqj/6